Filter
Top Products
2-10
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter 2 Starting and Stopping Cisco WAN Manager
Starting Additional CWM GUIs
Step 4 Set the DISPLAY environmental variable by entering the following:
setenv DISPLAY ip_address:0.0
where ip_address is the IP address of the workstation from which you have issued the telnet command.
Step 5 Launch CWM by entering CWM, then select Start Desktop from the main menu.
Note CWM core processes running on a workstation can be stopped from any other workstation that is running
a remote CWM session. For example, when you log into a workstation running the CWM core processes
and select Stop Core (Option 2), you are terminating the CWM core processes for not only yourself, but
for all others using those CWM core processes. Therefore, you must be careful not to select the Stop
Core option when you are through. Take care to close only the windows you have opened remotely, and
at the CWM main menu, select X to exit the application.