Filter
Top Products
9-12
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter 9 Summary Report and Wingz Report
Configuring Summary Reports
Node Name
Specify the node and interface shelf names for the end point in this field. Click on the “...” button to
display the Node:Shelf Selection window. Select a node name and corresponding shelf name from this
window. The default is all connections (this field is blank).
Slot.Line.Port
Specify the end-point’s slot and port numbers in this field. The default is all ports (this field is blank).
Connection List
This region is populated when you select the Filter button. All connections matching the filter criteria
are displayed in this region. Select a single entry from the list for plotting.
Each entry in the list has the following format:
Connection Identifier—the local and remote endpoints are displayed in this column. When certain
fields are not applicable, “..” is displayed. For example, for routing nodes, <interfaceshelfname> is
displayed as “..”.
• The format of the endpoints is as follows:
–
For Frame Relay: <nodename>.<interfaceshelfname>.<slot>.<line>.<port>.<DLCI>
–
For ATM: <nodename>.<interfaceshelfname>.<slot>.<line>.<port>.<vpi>.<vci>
–
For CE, Voice, and Data: <nodename>.<interfaceshelfname>.<slot>.<line>.<port>
• Type—the end-point types for the local and remote ends are displayed in this column.
• CIR—the CIRs for the local and remote ends are displayed in this column.
Report Type Pane
The Report Type pane is comprised of the following components:
Include Peak Data
Specify Include Peak Data along with Peak Interval to display the highest value in that interval.
Peak Interval
Select peak intervals from the values of 1, 5, 6, 10, 12, and 15 minutes if the Include Peak Data button
has been enabled. The default value is 5 minutes (300 seconds).
Note You must select the same peak interval as the one enabled during statistics collection.
Plot Duration
Selections for time of day (TOD), previous hour (Prev Hour), previous day (Prev Day), and previous
week (Prev Week) are displayed. The default value is TOD.