Filter
Top Products
B-4
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Appendix B Networking
Configuring Network Management
Figure B-1 In-Band Management - Basic Hub Attachment Without Router
Note Use valid IP addresses for devices in your network and avoid using upper-case characters in the files.
The addresses provided in the following examples should be replaced with your network’s device
addresses.
Step 1 Modify the /usr/users/svplus/config/network.conf file to include the name of the Gateway node in the
third field to igx2, and change the last field (IP Reachability Flag) to nwip_off.
The options for the IP Reachability Flag are:
• NWIP_OFF—for in-band management
• NWIP_ON—for out-of-band management
The contents of the network.conf file should look similar to the following:
NETWORK:Network1
GATEWAYS:igx2
DISCOVERY PROTOCOL:AUTOROUTE
IP REACHABILITY FLAG:NWIP_OFF
Step 2 Modify the /etc/hosts file to include (along with the file’s usual contents) the IP addresses and device
names described in Step 3.
Step 3 Modify the /etc/rc2.d/S72inetsvc file to add routes by adding a lines similar to the following:
CWM
workstation
172.70.207.5
Link 0
Link 0
Link 1
Link 1 Link 1
SNMP
TFTP
SNMP
TFTP
IGX2
Gateway node
IP-Lan 172.70.207.6
IP-Relay 192.0.0.6
IGX3
IP-Relay
192.0.0.7
BPX4 IP-Relay
192.0.0.8
IP-Relay
192.0.0.9
IP-Relay
192.0.0.10
IP-Lan
172.70.207.9
IP-Lan
172.70.207.10
"cnfifip"
37-ATM
"cnfifip"
26-ETHERNET
17941
AXIS1
AXIS2
IP Address Device Name
172.70.207.6 igx2-lan
192.0.0.6 igx2
192.0.0.7 igx3