Filter
Top Products
13-6
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter 13 Saving and Restoring Node Configurations
Switch CLI Save and Restore
Figure 13-5 dspcnf Command Output
Loaded firmware images must be cleaned up before invoking savecnf. To remove the loaded firmware
image, invoke the getfwrev command on the node and specify 0.0 as the firmware revision level, as in
the following:
getfwrev <card_type> 0.0 <node>
Step 3 Save the node’s configuration using the savecnf command. The syntax for the savecnf command is given
below:
savecnf <backup_id|clear> <node_name|*> <dest_SV_node> [<dest_SV_ip>]
A typical savecnf command invocation is shown below with its output shown in Figure 13-6:
savecnf C051598 nmsbpx14 nmsbpx14 172.29.23.25