Filter
Top Products
2-4
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter 2 Starting and Stopping Cisco WAN Manager
Stopping Cisco WAN Manager
• coldstartSCM -F
To perform a cold start of CWM, complete the following steps:
Step 1 At the CWM workstation, enter CWM to display the main menu.
Step 2 From the CWM main menu, enter 2 to select the Stop Core option, then confirm that you want to stop
core by responding y to the prompt.
It might take several minutes for all of the processes and messages to end, depending upon the number
of nodes in the network.
Step 3 Press Return to redisplay the CWM main menu.
Step 4 From the main menu, enter x to exit the CWM application.
Step 5 Enter create_db.
Dozens of messages will be displayed, starting with the message dropping db. Additional messages will
indicate that tables are being created and procedures stored. The shell prompt will return in less than a
minute.
Step 6 At the CWM workstation, enter CWM to redisplay the main menu.
Step 7 From the main menu, enter 1 to select the Start Core option.
Step 8 When the CWM main menu is displayed, enter 3 to launch the CWM Desktop.
Stopping Cisco WAN Manager
This section provides information about stopping CWM. This section includes the following procedures:
• Stopping the CWM application
• Stopping the CWM application and powering off the workstation
Stopping CWM
To stop the CWM application, complete the following steps:
Step 1 Close the HP Openview application (if it is running) by selecting Map > Exit from any Openview
window and click OK when prompted to confirm the operation.
Step 2 Close the CWM Desktop by selecting File > Exit from the Desktop main window.
Step 3 If the Statistics Manager is running, select File > Quit and click OK when prompted to confirm the
operation.
Step 4 Close any other CWM applications, such as Connection Manager, that might be currently running.
Step 5 From the CWM main menu, enter 2 to select the Stop Core option, then confirm that you want to stop
core by responding y to the prompt.
It might take several minutes for all of the processes and messages to end, depending upon the number
of nodes in the network.
Step 6 Press Return to redisplay the CWM main menu.