Filter
Top Products
A-8
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Appendix A Internet Connectivity
SVC Connections
Sample Configuration 2
The first sample configuration provides the following features:
• Routers do not support ATMARP
• Routers support VC Based Multiplexing encapsulation
• Routers do not support ILMI
• Routers support RIP protocol
• IP Host routing used for IP Connectivity network
• PNNI extension not supported for discovering router AESA
• CWM Workstation does not support RIP protocol
MGX 8850 Configuration
The following MGX 8850 Release 2 configuration is required.
Step 1 Configure IP address of IPATM interface.
ipifconfig atm0 172.29.24.190 arp
Step 2 Configure local AESA:
svcifconfig atm0 local 47.0091.8100.0000.1010.1010.1010.1010.1010.1010.10
Step 3 Configure router AESA of Router:
svcifconfig atm0 router 47.0091.8100.0000.0101.0101.0101.0101.0101.0101.01 noarp vcmux
Router Configuration
You must configure a static route that specifies endpoint for router AESA so that PNNI learns about this
endpoint.
Step 1 Configure IP address of ATM interface.
interface atm 0
ip address atm0 172.29.23.118 255.255.0.0
Step 2 Configure local AESA:
atm nsap-address 47.0091.8100.0000.0101.0101.0101.0101.0101.0101.01
Step 3 Configure the signalling PVC:
atm pvc 1 0 5 qsaal
Step 4 Configure UNI 3.1:
atm uni-version 3.1