Filter
Top Products
xxiii
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Preface
Related Documentation
Cisco MGX 8850 Release 2.1 Documentation
The product documentation for the installation and operation of the MGX 8850 Release 2.1 switch is
listed in Table 4.
Table 3 WAN CiscoView Release 10 Documentation
Title Description
WAN CiscoView Release 3 for the MGX 8850 Edge Switch,
Release 1
DOC-7811242=
Provides instructions for using this network management
software application that allows you to perform minor
configuration and troubleshooting tasks.
WAN CiscoView Release 3 for the MGX 8250 Edge
Concentrator, Release 1
DOC-7811241=
Provides instructions for using this network management
software application that allows you to perform minor
configuration and troubleshooting tasks.
WAN CiscoView Release 3 for the MGX 8230
Multiservice Gateway, Release 1
DOC-7810926=
Provides instructions for using this network management
software application that allows you to perform minor
configuration and troubleshooting tasks.
Table 4 Cisco MGX 8850 Switch Release 2.1 Documentation
Title Description
Cisco MGX 8850 Routing Switch Hardware Installation
Guide, Release 2.1
DOC-7812561=
Describes how to install the MGX 8850 routing switch. It
explains what the switch does, and covers site preparation,
grounding, safety, card installation, and cabling.
Cisco MGX 8850 and MGX 8950 Switch Command
Reference, Release 2.1
DOC-7812563=
Describes how to use the commands that are available in the
CLI
1
of the MGX 8850 and MGX 8950 switches.
1. CLI = command line interface
Cisco MGX 8850 and MGX 8950 Switch Software
Configuration Guide, Release 2.1
DOC-7812551=
Describes how to configure the MGX 8850 and the MGX 8950
switches to operate as ATM edge and core switches. This guide
also provides some operation and maintenance procedures.
Cisco MGX 8850 and MGX 8950 SNMP Reference,
Release 2.1
DOC-7812562=
Provides information on all supported MIB
2
objects, support
restrictions, traps, and alarms for the AXSM, PXM45, and RPM.
PNNI is also supported.
Cisco MGX and SES PNNI Network Planning Guide
DOC-7813543=
Provides guidelines for planning a PNNI network that uses the
MGX 8850 and the MGX 8950 switches and the BPX 8600
switches. When connected to a PNNI network, each BPX 8600
series switch requires a Service Expansion Shelf (SES) for PNNI
route processing.
Cisco MGX Route Processor Module Installation and
Configuration Guide, Release 2.1
DOC-7812510=
Describes how to install and configure the MGX Route Processor
Module (RPM-PR) in the MGX 8850 and MGX 8950 Release 2.1
switch. Also provides site preparation, troubleshooting,
maintenance, cable and connector specifications, and basic IOS
configuration information.