Filter
Top Products
Page 166 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Install the NTMF94EA cable (for non-DCHIP cards)
1 Connect the NTMF94EA cable (see Figure 25) to the I/O panel
connector. Make sure to connect to the I/O panel connector which
corresponds to the left slot number of the DCHIP card.
2 Secure the mounting screw provided on the top of the Shielded 25-Pair
Amphenol Connector to the I/O Panel filter connector in order to tie the
shield of the LAN cable to the Meridian 1 frame ground for EMC
compliance.
Figure 25
NTMF943A E-LAN, T-LAN and serial port cable
Shielded RJ-45 Cable
Mountin
g
Screw
Shielded 25-Pair
Matin
g
Coupler
Shielded RJ45
Amphenol Connector
To Hub
9 Pin D-Sub
Female
Ferrite
To Hub