Filter
Top Products
Page 234 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
9 If MAT Alarm Notification is running (i.e., the red traffic light is showing
on the tool bar), first stop it by clicking on the red traffic light on the tool
bar. Restart it by clicking on the green traffic light.
10 If MAT Alarm Notification is not running (i.e., green traffic light is
showing on the tool bar), start it by clicking on the green traffic light to
change it to red.
11 Enter the trap_gen command from the ITG shell. A series of SNMP
traps is emitted by the ITG card and appears in the MAT Alarm
Notification browser window. Verify the device name identifies the
correct ITG card.
The procedure is complete.
Make test calls to the remote ITG nodes
Make test calls to check that:
• the ITG system can process calls from each node to a remote node,
• the ITG trunk cards are enabled,
• the Quality of Service, as defined within the Dialing Plan window, is
acceptable.
Check the ITG operational report. If Fallback to PSTN occurs, examine the
IP data network for problems. Also, check the ITG cards’ dialing plan table
and verify that the remote ITG node is powered up, configured, and enabled.