Filter
Top Products
Install and configure ITG ISL Trunk node Page 169 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Install filter and NTND26 cable (for MSDL and DCHIP
cards in same Large System equipment row)
1 Install the bracket for the 15-pin I/O panel filter connector in one of the
two smaller openings (J2, J3, J4, J5) of the I/O panel of the IPE Module
that contains the DCHIP card.
2 Install the 15-pin I/O panel filter connector on the inward side of the
bracket.
Figure 26
15-pin filter connector installation
S
y
stem I/O Panel
Mountin
g
Screw
System
Backplane
Side
(Inside I/O
Panel)
Exterior side of
System (to MDF
etc.)
NTND26AA
Cable Insertion
NTMF04BA
insertion