Filter
Top Products
Page 266 of
378
OA&M using MAT applications
553-3001-202 Standard 1.00 April 2000
The following is the recommended method to create the “dummy” ITG node.
1 In MAT Navigator add a site named “Retrieve ITG data.”
2 Add system named “Dummy,” of type “Meridian 1,” under the site
named “Retrieve ITG data.”
3 Add Customer Number “99” on the “dummy” Meridian 1 system.
When you need to view the data of a real ITG node, select the “dummy” node
and change the management IP address in the node properties to access the
needed node. Use the menu
Configuration | Synchronize | Retrieve
function
to retrieve data from that node and overwrite the dummy node’s data.
Configuration audit
In this procedure, you retrieve the card properties and dialing plan from each
card in the selected nodes. MAT compares the retrieved data with the card
properties and dialing plan currently stored in the MAT database. MAT
provides a report that shows cards where the data matches and cards where
the data is different. To view the differences, use the menu
Configure | Node
| Add
to add a temporary node. Then use the menu
Configure | Synchronize
| Retrieve
to retrieve the card properties or dialing plan from the selected
card. Double-click on the temporary node to view the card properties and
open the dialing plan for the temporary node to view the dialing plan entries.
Compare the data with the properties and dialing plan for the currently stored
node in MAT.
Retrieve ITG configuration information from the ITG node
You can use this optional procedure when you:
• add an ITG node on MAT by retrieving an existing node
• know that the ITG node configuration on the ITG card is different from
the MAT ITG database (e.g., during maintenance and fault isolation
procedures).
• have multiple MAT PCs with multiple instances of the database
(administration).