Filter
Top Products
OA&M using the ITG shell CLI and overlays Page 289 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Download the ITG error log
The ITG error log contains error conditions and normal events. Some of the
error conditions can be severe enough to raise an alarm through SNMP traps.
The following commands can download an ITG error log:
• currLogFilePut
• prevLogFilePut
Meridian 1 system commands - LD 32
You can perform the following Meridian 1 system administration commands:
• “Disable the indicated ITG card” on page 291.
Note 1: The ITG card must be disabled before card properties can be
transmitted from the MAT ITG application to the card.
Note 2: The card reset button is only available in the MAT ITG
application when the card is disabled.
Note 3: Disabling the ITG card in overlay 32 does not disable the active
leader or backup leader functions.
• “Disable the indicated ITG card when idle” on page 291.
Note: This will temporarily prevent the ITG node from seizing the port
from incoming calls.
• “Disable an indicated ITG port” on page 291.
• “Enable an indicated ITG card” on page 292.
• “Enable an indicated ITG port” on page 292.
• “Display ITG card ID information” on page 292.
Note 1: This command displays the PEC (Product Engineering Code)
for the card. The ITG PEC is NT0961AA.
Note 2: The ITG card information displays the same ITG card serial
number that is displayed from the ITG shell using the
serialNumShow
.
• “Display ITG card status” on page 292.