Filter
Top Products
OA&M using MAT applications Page 271 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Note: This will temporarily prevent the ITG node from seizing the port
from incoming calls.
• “Disable an indicated ITG port” on page 273.
• “Enable an indicated ITG card” on page 273.
• “Enable an indicated ITG port” on page 273.
• “Display ITG card ID information” on page 274.
Note 1: This command displays the PEC (Product Engineering Code)
for the card. The ITG PEC is NT0961AA.
Note 2: The ITG card information displays the same ITG card serial
number that is displayed from the ITG shell using the
serialNumShow
.
• “Display ITG card status” on page 274.
• “Display ITG card port status” on page 274.
A summary list of ITG Meridian 1 system commands is shown in Table 42
on page 271.
Table 42 shows a summary of the Meridian 1 system administration
commands available in overlay 32.
Table 42
Overlay 32 - ITG maintenance commands
Command Function
DISC l s c Disable the indicated card,
where: l = loop, s = shelf, c = card
DISI l s c Disable the indicated card when
idle, where: l = loop, s = shelf,
c = card
Note: you should use the DISI
command to disable the ITG card
instead of the DISC command. The
disablement of the ITG card is
indicated by the NPR011 message.