Filter
Top Products
Install and configure ITG ISL Trunk node Page 197 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
b Enter the Management MAC address. It is the motherboard
Ethernet address. You can find it on the faceplate label of the card
you are currently configuring. It is also identified as lnIsa0 on the
card startup messages and by the ifShow command in the ITG
shell.
The Management LAN Node IP and Management gateway IP
addresses on the General tab and the Management IP address for
Leader 0, Leader 1 and all Follower cards on the Card Configuration
tab must be on the same Voice/Management E-LAN subnet.
5 Enter the Card TN. For Large Systems, card TNs are validated for
loop, shelf and card separated by dashes. For Small Systems, only the
card number is required.
6 Select the Card Density from the drop-down list box: 24 ports for
NT0961AA; 8 ports for NTCW80.
7 Enter the ISL D-channel logical device number. Its range is 0-255 for
Large Systems; 0-79 for Small Systems.
8 If the card will be a DCHIP card, check the DCHIP is on this Card
check box. The DCHIP card must have an NTWE07AA DCHIP PC
Card with an NTCW84EA Pigtail cable installed and must be
connected to the ISL DCH port on the MSDL or SDI/DCH card.
Note:
The standard configuration is to put the first DCHIP on Leader
0 and the second DCHIP on Leader 1. Additional DCHIPs can be put
on Follower cards.