OA&M using the ITG shell CLI and overlays Page 281 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Reset the operational measurements
This command resets all operational measurement (OM) parameters collected
after the last log dump.
At the ITG shell prompt, type:
resetOM
.
Display the number of DSPs
At the ITG shell, enter the following command to display the number of DSPs
on the ITG card:
DSPNumShow
Display ITG Node Properties
ITG> enter the following command to display information about an ITG
node:
IPInfoShow
The following ITG node information appears on the TTY:
• IP addresses for the management and voice subnets
• default router for the management and voice subnets
• subnet mask for the management and voice subnets
• SNMP manager
Enter the following command to display information about an ITG card:
itgCardShow
The following commands give additional information about an ITG card:
• ldrResTableShow
• ifShow
• dongleIDShow
• serialNumShow
• firmwareVersionShow
• swVersionShow
• emodelSim