Filter
Top Products
Page 286 of
378
OA&M using the ITG shell CLI and overlays
553-3001-202 Standard 1.00 April 2000
5 When the new software has downloaded into the flash ROM device,
you must reboot the ITG card to use it. Use the cardReset command
or press the reset button on the card faceplate.
Up
g
rade ITG card software via an FTP host
1 The latest ITG card software, which was obtained from the Nortel
Networks web page, must be made available to an FTP host. This can
be an FTP host on the PC. As a special case, the FTP host can be the
ITG card.
Alternatively, you can use an FTP client running on the PC to put the
ITG card software file on an ITG host available by the ITG card on the
network.
For example, any ITG card on the same node can serve as the FTP
host. The file can be put onto the C: drive of the ITG card serving as
the FTP host.
2 Use the swDownload command to copy the software from the PC
card to the ITG card flash ROM device, using the FTP client and the
FTP host on the card. The host name parameter in this command is
the IP address of the FTP host, which can be local or remote to the ITG
card. The user name and password are the user name and password
of the FTP host. The directory path and file name are the directory path
and file name on the FTP host. As a special case, the FTP host can be
the ITG card, and the directory path is "/C:".
3 Press Enter. Monitor the status of the software upgrade, and check
that the upgrade correctly finishes. Observe any error messages that
indicate problems with parameters or syntax.
4 When the new software has downloaded into the flash ROM device,
you must reboot the ITG card to use it. Use the cardReset command
or press the reset button on the card faceplate.