Filter
Top Products
Page 204 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure SNMP Traps/Routing and IPs tab
In this procedure, you define up to eight SNMP Trap destination IP addresses
and subnet masks, and up to eight Card Routing Table Entry IP addresses and
subnet masks. These SNMP trap and Card routing table settings become
active when you transmit the card properties to the ITG trunk cards.
1 Click SNMP Traps/Routing and IPs tab (see Figure 33).
2 Check the Enable SNMP traps check box to enable sending of SNMP
traps to the SNMP managers that appear in the list. You must enter at
least one SNMP trap address if you check this option. The SNMP trap
addresses determine where event and alarm messages are sent.
Refer to “Configure MAT Alarm Management to receive SNMP traps
from ITG ISL Trunk cards” on page 231 to configure MAT Alarm
Notification to monitor SNMP traps for ITG cards.
Figure 33
ITG Node Properties window – SNMP Trap Addresses/Routing table IPs tab