Filter
Top Products
Page 178 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure ISDN feature in customer data block
Configure ITG ISL TIE trunk routes
Table 33
LD 15 - Configure ISDN feature in customer data block
Prompt Response Description
REQ CHG Change customer data block.
TYPE NET_DATA Gate-opener for networking features.
CUST xx Customer number associated with this customer
data block.
OPT a....a Options.
AC2 aaa bbb ccc ESN call types under AC2 for the INAC feature.
For example, NPA NXX INTL SPN LOC. INAC
stands for automatic insertion of the ESN access
code on incoming calls.
Note:
By default, the INAC feature puts all ESN call
types except for CDP under AC1. You enable or disable
INAC per trunk route in LD16 in the IDSN section of the
route data block.
ISDN YES (NO) You must enter YES to configure ITG ISL routes.
- PNI (0) - 32700 Private Network Identifier. You must configure the
PNI to 1 or other non-zero value to support
Meridian Customer Defined Network (MCDN)
features that use non-call-associated signaling.
For example, Network Ring Again (NRAG)
Network Message Services (NMS), Network ACD
(NACD). Each feature needs ISDN signaling to be
sent across the Meridian 1 network in the absence
of a call.
Note:
The PNI in the customer data block must be the
same as the PNI configured in the route data block at the
far end for outgoing calls from the far-end toward this
Meridian 1 node.
... ... ...