Filter
Top Products
Page 202 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
5 Click the Codec Options tab (see Figure 32). This tab displays the
default order of the preferred codec selection for outgoing calls and
shows advanced codec parameters for the selected codec.
Perform steps 6 and 7 if required. To revert to the default settings, click
Reset Defaults.
Figure 32
ITG Node Properties – DSP Profile Codec Options tab
CAUTION
The default Codec Options are appropriate for most applications. If you
are not an expert in Voice over IP, do not modify the Codec Options
parameters. See “ITG Trunk DSP profile settings” on page 135.