Filter
Top Products
Page 252 of
378
OA&M using MAT applications
553-3001-202 Standard 1.00 April 2000
ITG Card Properties – Configuration window
The Configuration window for the ITG card contains the information shown
in Figure 48. The ITG Card Properties Configuration window provides
read-only information. Go to the Node Properties Card Configuration
window to change this data. The Software version is retrieved from the card
through the MIB. If the card is not responding, the value is set to “Unknown”.
Note: For more information about maintenance commands, see
“Maintenance” on page 295.
DSP maintenance window
Note: If the ITG card is not responding, no DSP icons appear in the tree
on the left-hand side of the ITG Card Properties window.
Click on the required DSP icon in the tree on the left-hand side of the ITG
Card Properties window. The DSP Maintenance window appears which
contains the state of the DSP and the Self Test command. Click on the Self
Test button to perform a self test on the DSP. The command is sent to the ITG
card through SNMP.
Figure 48
ITG Card Properties Configuration tab