Filter
Top Products
OA&M using the ITG shell CLI and overlays Page 283 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Software upgrade
Use this command in the procedure “Transmit new software to ITG Trunk
cards” on page 227.
• swDownload "hostname","username","password",
"directory path","filename"
Generic file transfer:
Use these commands for debug purposes. The first five parameters refer to the
FTP host. The "ITGFileName" parameter refers to the directory path and file
name on the ITG card. The "listener" parameter in the ’hostFileGet’
command identifies a software module to be called to parse the file after it has
been correctly transferred to the ITG card. To avoid damaging the
configuration files and ITG card, only use the ’hostFileGet’ command under
the direction of Nortel Networks support personnel .
• hostFileGet "hostname","username","password" ,
"directory path","filename","ITGFileName","listener"
• hostFilePut "hostname","username","password",
"directory path","filename","ITGFileName"
Configuration file transfer
Use these commands to backup and restore files when the preferred means,
the MAT ITG PC, is not available.
• DPAddrTGet "hostname","username","password",
"directory path","filename"
• DPAddrTPut "hostname","username","password",
"directory path","filename"
• configFileGet "hostname","username","password",
"directory path","filename"
• configFilePut "hostname","username","password",
"directory path","filename"
• bootPFileGet "hostname","username","password" ,
"directory path","filename"