Filter
Top Products
Page 288 of
378
OA&M using the ITG shell CLI and overlays
553-3001-202 Standard 1.00 April 2000
3 Log in to the ITG shell for each card that requires a Card Properties
restore and use the configFilePut command with the appropriate
parameters, to restore the card properties files.
Note that the keycode for each card is located in the specific card
properties file. Card properties files are not interchangeable.
Recover the SNMP community names
Use this procedure when MAT ITG cannot display the updated status or to
transmit or retrieve data to or from an ITG card because of an invalid
community name in MAT ITG. This procedure can be used if the MAT PC
has crashed, and had to be restored from scratch.
The SNMP community names can be read from the ITG card in two ways:
• Reset the card and monitor the start up messages.
• Use the configFilePut command to backup the Card Properties file to an
FTP host and subsequently use a text editor to open the Card Properties
file and read the community name.
Alternatively, use the SNMP client on the MAT PC to connect to the FTP
host on the ITG card and log in using the ITG shell user name and
password. Get the Card Properties file from the path, which is
"/C:config/config1.ini". Use a text editor to open the Card Properties file
and read the community name.
IP configuration commands
The one command that does all the necessary actions to make a leader. Sets
IP address, gateway, subnet mask, boot method to static, and leader bit in
NVRAM.
• setLeader
Enter this command to clear the leader information in NVRAM and set the
boot method to use bootp, making the card a follower:
• clearLeader
Enter this command to print the values of the IP parameters that exist in
NVRAM.
• NVRIPShow