Filter
Top Products
Page 182 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure ITG ISL trunk cards and units
Record the first CHID for each ITG ISL Trunk card on the installation
summary sheet.
NEDC ETH Near end disconnect control from either originating
or terminating side.
FEDC ETH Far end disconnect control from either originating
or terminating side.
...
Table 35
LD 14 - Configure ITG ISL 8- or 24-port trunk cards and units (Part 1 of 3)
Prompt Response Description
REQ NEW XX Add new data, where:
xx = 1-8 for NTCW80 8-port ITG Trunk card
xx = 1-24 for NT0961AA 24-port ITG Trunk card
When using REQ = NEW XX, configure only one
ITG Trunk card at a time.
When using REQ = NEW XX, CHID is
incremented for each of the new units created.
You may need to configure partial ITG Trunk cards
due to WAN traffic capacity limitations, or Leader
and DCHIP card real-time capacity for very large
nodes and networks.
TYPE TIE Trunk Type.
TIE is the only supported trunk type for ITG ISL
Trunks.
Table 34
LD 16 - Configure the ITG ISL TIE Trunk route data block (Part 4 of 4)
Prompt Response Description