Filter
Top Products
Page 276 of
378
OA&M using the ITG shell CLI and overlays
553-3001-202 Standard 1.00 April 2000
• “IP configuration commands” on page 288.
• “Download the ITG error log” on page 289.
Access the ITG shell through a maintenance port or Telnet
You can access the ITG shell administration and maintenance commands in
two ways:
You can log in through a direct cable connection between the ITG faceplate
maintenance port and the MAT PC.
You can access the ITG shell from the MAT PC. Refer to “Telnet to an ITG
card through the MAT PC” on page 277 for details.
Connect a PC to card maintenance port
1 To access the ITG shell, connect a PC to the RS232 serial
maintenance port through DIN-8 connector on the faceplate of the ITG
Leader 0 card through an NTAG81CA PC Maintenance cable. If
required, use an NTAG81BA Maintenance Extender cable to provide
an extension between the NTAG81CA PC Maintenance cable and the
MAT PC.
Alternatively, connect the NTAG81BA Maintenance Extender cable to
the female DB - 9 connector of the NTCW84KA E-LAN, T-LAN, DCH,
and Maintenance Port cable (for DCHIP cards), or the NTMF94EA
E-LAN, T-LAN, Maintenance Port cable (for non-DCHIP cards, to
create a more permanent connection to the ITG Trunk card serial
maintenance port.
Note:
Never connect two terminals to the front and back serial
maintenance port connectors at the same time.
2 Use the following communication parameters for the TTY terminal
emulation on the PC: 9600 baud, 8 bits, no parity bit, one stop bit.
3 When prompted to login, enter current username and password.
Default is:
VxWorks login: itgadmin
Password: itgadmin
ITG>