Filter
Top Products
Install and configure ITG ISL Trunk node Page 217 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
4 When the ITG shell prompt appears on the TTY, enter the IP address
for the Leader card:
Wait until the display shows "T:21," then enter:
ITG> setLeader “xxx.xxx.xxx.xxx”, “yyy.yyy.yyy.yyy”,
”zzz.zzz.zzz.zzz”
Where:
• “xxx.xxx.xxx.xxx” is the Management IP address of Leader 0
on the E-LAN,
• where “yyy.yyy.yyy.yyy” is the Management Gateway (Router)
IP address on the E-LAN. If the MAT PC will be connected
locally to the LAN, and there is no management LAN gateway,
then the Gateway IP address is “0.0.0.0”.
• and where “zzz.zzz.zzz.zzz” is the subnet mask for the
management IP address of Leader 0 on the E-LAN.
Note 1:
All ITG shell commands are case-sensitive. A space
separates the command from the first parameter. The three
parameters must each be enclosed in quotation marks, and there must
be a comma and no spaces separating the three parameters.
Note 2:
The Management Gateway (Router) IP address is used on
reboot to create the IP route table default network route only if 1) there
is no active leader that has this card’s management MAC address in
its node properties file, and 2) this card’s node properties file is empty
(size 0 Kb).
Note 3:
IP addresses and subnet masks must be entered in dotted
decimal format.
Note 4:
If the network administrator has provided the subnet mask in
CIDR format, you must convert it to dotted decimal format before
entering it. For example: 10.1.1.1/20 must be converted to IP address
10.1.1.1 with subnet mask 255.255.240.0. To convert subnet mask
from CIDR format to dotted decimal format refer to
Appendix D
.
5 Press Enter.