Filter
Top Products
Appendix D: Configure a Netgear RM356 modem router for remote access Page 365 of
378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
19 Type in the user name. Toggle "Active=Yes/No" for security purposes.
Type in a password for PAP. The DUN client on the remote MAT PC
must provide the user name and password defined here when dialing
up the modem router.
Set "Callback=Yes/No" according to the customer's network security
policy and practices. Nortel Networks Customer Technical Services
(CTS), does not currently accept callback security calls from the
modem router.
Set "Rem CLID=" to the PSTN Calling Number that is displayed when
the remote MAT PC dials up the modem router, if CLID authentication
is required for the user profile. CLID depends on providing a C.O. line
subscribed for CLID service for the modem router's telephone line
connection.
Set "Idle Timeout=1200" seconds to provide 20 minutes idle timeout
disconnect for Nortel Networks remote support purposes.
Press Enter to confirm and save data to ROM, then press Esc to return
from the sub-menu to the main menu.
20 Enter menu selection number 23 to access "System Password" under
the "Advanced Management" section of the "RM356 Main Menu."
"Menu 23 - System Password" is displayed.
21 Type in the old password and new password, then retype the new
password to confirm. Never leave the RM356 system manager
password defaulted to 1234 after the modem router has been installed
and configured on the E-LAN. The modem router's security features
are worthless if the manager password is not changed regularly
according to good network security practices.