Filter
Top Products
Page 214 of
378
Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
9 Check only the Dialing Plan check box if the community name for both
the existing and new nodes is the same.
Check the Dialing Plan check box and the Prompt user for
community name check box if the community name for both the
existing and new nodes are different. A dialog box will appear asking
you to enter the new node’s community name.
10 Click Start Retrieve and monitor progress in the Retrieve control field.
Make sure the dialing plan is retrieved successfully and added to the
MAT database.
11 Click Close to close the ITG Retrieve Options window and return to the
IP Telephony Gateway - ISDN IP Trunk Main window.
12 Select the new node and double-click to open its Node Properties
sheet.
13 On the Configuration tab, change the Management IP address of
Leader 0 on the new node. Enter the correct Management IP address
of the Leader 0 card on the new node.
14 Click Change and then click OK.
15 Select menu Configuration | Node | Dialing Plan to open the ITG
Dialing Plan window.
16 Inspect the retrieved dialing plan for the new node and make any
necessary modifications. Double-click on an dialing plan entry to
inspect its property sheet. To save modifications, click Apply and then
OK.
From the View menu, you have the option of viewing by Digits dialed
or Remote Nodes.