Filter
Top Products
Tutorials
2-62 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Output the Waveform
Do the following steps to load and output the saved waveform:
1. Push the SETUP button on the front panel to display the SETUP menu.
2. Load the file ABC45.wfm.
Refer to Load a Sample Waveform on page 2-54 if you need help.
3. Push the RUN button on the front panel to output the analog waveform.
4. Push the CH 1 button near the CH 1 output connector on the front panel. If you
connected an oscilloscope to the AWG710&AWG710B Arbitrary Waveform
Generator, observe that the waveform on the oscilloscope is the same as the
one you viewed in Figure 2-38.
You have completed the Creating and Editing Standard Function Waveforms
tutorial.
NOTE. Pushing the RUN button causes the instrument to output the waveform.
Push the RUN button again to stop the output. The instrument does not
automatically output the waveform from a newly–loaded file.