Filter
Top Products
The Graphical Waveform Editor
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-65
Horizontal Invert...
The Horizontal Invert... command horizontally inverts (flips) the edit area
waveform and marker data. You can invert the waveform and marker data
separately. This command does not change the waveform data record length.
Do the following steps to horizontally invert the waveform or marker data:
1. Move the cursors to specify the edit area to invert.
2. Push Operation (bottom)!Horizontal Invert... (pop–up)!OK (side).
3. Push the Data, Marker1, or Marker2 side button to specify which data to
invert.
4. Push the Exec side button.
The data in the edit area inverts (flips) horizontally.
Vertical Invert...
The Vertical Invert... command vertically inverts (flips) the edit area waveform and
marker data. You can invert the waveform and marker data separately. This
command does not change the waveform data record length.
Do the following steps to vertically invert the waveform or marker data:
1. Move the cursors to specify the edit area to invert.
2. Push Operation (bottom)!Vertical Invert... (pop–up)!OK (side).
3. Push the Data, Marker1, or Marker2 side button to specify which data to
invert.
4. Push the Exec side button to vertically invert the cursor–to–cursor data you
have specified in Step 3.
Clip...
The Clip... command sets the edit area waveform data maximum upper or lower
signal level to a specified value.
Do the following steps to clip the waveform data:
1. Move the cursors to specify the edit area to clip.
2. Push Operation (bottom)!Clip... (pop–up)!OK (side).
3. Push the Clip side button to specify the portion of level to be clipped. Select
either the Upper or Lower. Upper refers to all signal data located above the
origin, and lower refers to all signal data located below the origin.
4. Push the Level side button and specify the clip level using the general purpose
knob or numeric keys.
5. Push the Exec side button to clip the waveform data.