Filter
Top Products
Operating Basics
2-38 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Editing a Waveform
To edit the loaded waveform file, push the Edit... side menu button. The instrument
opens the appropriate edit window for the previously loaded file type.
If you have not loaded a file in the Setup screen, the instrument displays the
message No output data, and you cannot enter into the editor.
The editors are described in more detail in the Reference section beginning on page
3-55.
Setting Waveform Output
Parameters
The Setup side menus provide commands for setting and adjusting waveform
output parameters. The steps for setting output parameters are discussed in detail
in the Reference section beginning on page 3-33. Table 2-12 provides an overview
of the Setup side menu operations.
Table 2-12: Setup output parameter operations
Bottom
button
Side
button Description
Waveform/Seq
uence
Load...
View
Edit...
Displays the Select File dialog box that lists files in the current
drive and directory. Select a file to load or use the side menu
buttons to change drives and/or directories.
Displays the loaded file in a window. Push the OK side menu
button to close the view window.
Opens the appropriate editor for the loaded file.
Vertical Filter
Amplitude
Offset
Marker...
Output...
Selects lowpass filter to insert into signal path. Filter values
are Through (no filter), 20 MHz, 50 MHz, 100 MHz, and 200
MHz. Use the general purpose knob to enter new
values.(except option 02)
Sets the signal peak–to–peak amplitude in increments of
0.001 V. The maximum value is 2 V
p–p
in normal mode and 1
V
p–p
in direct mode. Use the general purpose knob or the
keypad to enter new values.
Sets the signal offset value in increments of 0.001 V. The
offset voltage range is ±0.5 V. Use the general purpose knob
or the keypad to enter new values.(except option 02)
Displays a side menu to set Marker 1 and Marker 2 signal high
and low values. The marker signal voltage range is -2.0 V to
2.45 V (-1.1 V to 3.0 V :AWG710) and maximum amplitude is
1.25 V
p–p
into 50 Ω ( 2.5 V
p–p
into 50 Ω : ΑΩΓ710). Use the
general purpose knob or the keypad to enter new values.
Toggles normal output to direct output.(except option 02)