Filter
Top Products
The UTILITY Window
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-163
Figure 3-52: Network setup screen menu
To let the network recognize the AWG710&AWG710B Arbitrary Waveform
Generator, set the IP address and Subnet Mask. If necessary, also set the Gateway
address by the steps below:
1. Push UTILITY (front–panel)!Comm (bottom) to display the network setup
screen menu.
2. Do the following steps to control the instrument through Ethernet.
a. Select Remote Control using y and b buttons.
b. Select Network.
3. Set an IP address of your AWG710&AWG710B Arbitrary Waveform
Generator in the IP Address field. To set the IP address, there are two methods:
Set the parameters manually:
a. Move the cursor to DHCP client field using y and b buttons, and select
Disabled using the general purpose knob or a ' buttons.
b. Move the cursor to IP Address field using y and b buttons, and push
Edit... side button.
c. Set the IP address in the IP Address setup dialog box.
d. If necessary, set a subnet mask in the Subnet Mask field.
Network setup parameters