Filter
Top Products
Appendix A: Specifications (AWG710B)
A-22 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Table A-24: Installation requirement
Characteristics Description
Heat dissipation
Maximum power 220 W max. (maximum line current: 3 A
rms
, at 50 Hz)
Surge current
30 A (25 °C) peak for equal to or less than 5 line cycles,
after the instrument has been turned off for at least 30s
Cooling clearance
To p,
Bottom
2 cm (0.8 in)
2 cm (0.8 in)
NOTE: The feet on the bottom provide the required clearance when set on a
flat surface.
Sides 15 cm (6 in)
Rear 7.5 cm (3 in)
Table A-25: Maintenance requirement
Characteristics Description
Calibration
The instrument should be fully calibrated at least every 12 months.
Table A-26: Environmental
Characteristics Description
Atmospherics
Temperature
Operating +10 °C to +40 °C
Non-operating -20 °C to +60 °C
Relative humidity
Operating 20 % to 80 % (no condensation)
Maximum wet–bulb temperature 29.4 °C
Non-operating 5 % to 90 % (no condensation)
Maximum wet–bulb temperature 40.0 °C
Altitude (Hard disk drive restriction)
Operating Up to 3 km (10 000 ft)
Maximum operating temperature decreases 1 °C each 300 m (1 000 ft) above 1.5 km (5 000
ft)
Non-operating Up to 12 km (40 000 ft)