Filter
Top Products
Appendix G: Sequence File Text Format
AWG710&AWG710B Arbitrary Waveform Generator User Manual G-3
Jump Settings
After the line descriptions, you place the jump setting descriptions as follows: They
can be omitted when you use the current settings.
TABLE_JUMP 0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0
LOGIC_JUMP -1,-1,-1,-1
JUMP_MODE LOGIC
JUMP_TIMING ASYNC
STROBE 0
Jump Table Definition. The 16 entries of the table definition follow the table jump
header TABLE_JUMP and a space, and must be delimited by comma (,):
TABLE_JUMP <space> <LLLL>, <LLLH>, <LLHL>, <LLHH>, <LHLL>,
<LHLH>, <LHHL>, <LHHH>, <HLLL>, <HLLH>, <HLHL>, <HLHH>, <HHLL>,
<HHLH>, <HHHL>, <HHHH>
Each of these entries must be:
<Entry>::= <Line Number> (range: 1 to 8000)
0 (No definition)
Logic Jump Definition. The 4 entries of the logic table definition follow the logic
jump header LOGIC_JUMP and a space, and must be delimited by comma (,):
Logic Jump <space> <Pin–0 logic>, <Pin–1 logic>,
<Pin–2 logic>, <Pin–3 logic>
<Pin–n logic>::= -1 (for X, don't care),
0 (for L, low state) or
1 (for H, high state)
Jump Mode Selection. The jump table or logic jump definition you define is
effective depending on the jump mode setting as follows:
JUMP_MODE <space> <jump mode>
<jump mode>::= TABLE, LOGIC or SOFTWARE
Jump Timing and Strobe Settings.
JUMP_TIMING <space> <timing>
<timing>::= SYNC or ASYNC
STROBE <space> <strobe>
<strobe>::= 0 (for Off) or
1 (for On)