Filter
Top Products
Appendix B: Performance Verification (AWG710B)
AWG710&AWG710B Arbitrary Waveform Generator User Manual B-41
c. Open SW3 of the ground closure to degenerate the event signal.
d. Verify that the oscilloscope displays the waveform in Figure B-21.
10. Check the EVENT IN connector pin 3 input:
a. Close the SW4 of the ground closure to generate an event signal on the
EVENT IN connector pin 3.
b. Verify that the oscilloscope displays the waveform shown in Figure B-25.
Figure B-25: Waveform output when SW4 is closed
c. Open SW4 of the ground closure to degenerate the event signal.
d. Verify that the oscilloscope displays the waveform in Figure B-21.
11. Check the EVENT IN connector pin 4 input:
a. Close the SW6 of the ground closure to generate an event signal on the
EVENT IN connector pin 4.