Filter
Top Products
Appendix B: Performance Verification (AWG710B)
B-40 AWG710&AWG710B Arbitrary Waveform Generator User Manual
a. Close SW2 of the ground closure to generate an event signal on the
EVENT IN connector pin 1.
b. Verify that the oscilloscope displays the waveform as shown in Figure B-23.
Figure B-23: Waveform output when SW2 is closed
c. Open the SW2 of the ground closure to degenerate the event signal.
d. Verify that the oscilloscope displays the waveform shown in Figure B-21.
9. Check the EVENT IN connector pin 2 input:
a. Close SW3 of the ground closure to generate an event signal on the
EVENT IN connector pin 2.
b. Verify that the oscilloscope displays the waveform shown in Figure B-24.
Figure B-24: Waveform output when the SW3 is closed