Filter
Top Products
Appendix A: Specifications (AWG710)
A-28 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Electrical Specification
Table A-30: Operation modes
Characteristics Description
Continuous Waveform is continuously output in this mode. When a sequence is defined, waveforms are
sequentially or repeatedly output in the order defined by the sequence. The extended
sequence functions such as trigger input, event jump, and so on are neglected in this mode.
Triggered Waveform is output only once when a trigger event is created. A trigger signal is created by
the external trigger input signal, GPIB trigger command, and/or pressing the front–panel
FORCE TRIGGER button. The extended sequence functions such as trigger input, event
jump, and so on are neglected in this mode.
Gated The waveform is output in the same way as in the continuous mode only when the gate is
opened. The gate is opened by the gated signal.
Note that the output is made from the top of the first waveform for every gate period. The clock
signal continuously outputs from the connector outside the gate period.
Enhanced The waveforms are sequentially or repeatedly output according to the procedures defined in
the sequence. All extended functions such as trigger input, event jump, and so on are effective
and waveforms are controlled for output by this functions in this mode.
Table A-31: Arbitrary waveforms
Characteristics Description
Waveform memory Memory length: 16 200 000 words (8 bits/1 word)
Op.01 Memory length: 32 400 000 words (8 bits/1 word)
Marker memory Memory length: 16 200 000 words (2 markers × 1 bit / 1 word)
Op.01 Memory length: 32 400 000 words (2 markers × 1 bit / 1 word)
Sequence memory Maximum 8000 steps
Sequence counter 1 to 65 536 and Infinite
Waveform data points Multiple of 4 in the range from 960 to 16 200 000 points
Op.01 Multiple of 4 in the range from 960 to 32 400 000 points
Data storage
Hard disk 10 G bytes
Floppy disk 1.44 M bytes