Filter
Top Products
Appendix B: Performance Verification (AWG710B)
AWG710&AWG710B Arbitrary Waveform Generator User Manual B-9
Figure B-3: EVENT IN connector pins and signals and ground closure connector
Loading Files
The following steps explain how to load files from the Performance
Check/Adjustment disk into waveform memory and/or sequence memory.
1. Insert the disk into the AWG710B Arbitrary Waveform Generator floppy disk
drive.
2. Select SETUP (front)!Waveform/Sequence (bottom)!Load... (side)!
Drive... (side).
The Select Drive dialog box appears as show in Figure B-4.
Figure B-4: Loading file; selecting storage drive
3. Select Floppy from the dialog box with the general purpose knob, and then
push the OK side button.
The Select Drive dialog box disappears, and the files in the floppy disk are
listed on the Select File dialog box.
4. Use the general purpose knob to select a file to be loaded from the dialog box,
and then push the OK side button.
The waveform or sequence you selected is loaded into the instrument, and the
instrument is also setup with the parameters stored in that file.