Filter
Top Products
The Pattern Editor
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-89
Code Conversion Table
When you push the Edit... side button, the code conversion table appears as shown
in Figure 3-19. Each code conversion table defines the template pattern that is used
for pattern matching with the source code. Use the Edit... side button to create a
new code conversion table. Alternatively, use the Open... side button to read an
existing code conversion table.
Figure 3-19: Code conversion table
Table 3-25: Code conversion commands
Commands Description
Open... Reads an existing code conversion table.
Save... Saves a code conversion table that was newly created or edited.
It is saved in an ASCII file and the cells are separated by commas.
Edit... Creates or edits a code conversion table.
Table 3-26: Code conversion parameters
Parameters Description
Past Source Corresponds to the previous source data, which is to the left of the current
noticed point. You can view up to eight points of past data.
Current Source Shows the source data you are currently looking up. You may specify up to 16
points, starting in the noticed point.
Next Source Specifies the source pattern that is further to the right of the portion read with
Current Source. You can look at up to eight points of data.