Filter
Top Products
The Sequence Editor
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-125
You can define two types of conditional jumps: a Logic Jump and a Table Jump.
You can also specify whether the jump occurs synchronously or asynchronously,
and whether to use an external strobe signal to sample the event values. These
features are discussed in the following text.
Logic Jump. The Logic Jump lets you specify the signal values on all four EVENT
IN lines for a single event that triggers the jump. You can specify high, low, or
don’t care values for each line.
Do the following steps to enter a logic jump line number:
1. Move the cursor to the line in which to set the Jump Logic value.
2. Move the cursor to Logic Jump column.
3. Push Jump Mode (bottom)!Logic (side) to select Logic.
The Logic Jump graphic is highlighted.
4. Push Data Entry (bottom)!Jump to Next (side) to specify a jump to the next
line when the event conditions are true.
5. Push Data Entry (bottom)!Jump Off (side) to clear the Jump Logic table
cell. Note that the currently edited line is set as a jump destination in this case.
6. Push Data Entry (bottom)!Jump to Specified Line (side) and Jump To to
indicate a jump to a specified line when the event conditions are true.
Use the general purpose knob, front–panel keypad, or keyboard numeric keys
to enter a line number.
7. Push Jump Mode. The instrument displays the Jump Mode screen.
The Logic jump mode is still selected.
8. Use the general purpose knob, front–panel arrow keys, or keyboard keys to
select the logic level for each of the four EVENT IN lines.
X = don’t care, L = low (false) logic level, and H = true (high logic level)
Table Jump. The Table Jump lets you specify a line jump for one or more of the 128
= 2
7
(16 = 2
4
:AWG710) possible logic levels of the EVENT IN lines. Undefined
(no line number entered) lines are ignored.
Do the following steps to enter values in the Table Jump table:
1. Move the cursor to the line in which to set the Jump Logic value.
2. Move the cursor to Logic Jump column.
3. Push Jump Mode (bottom)!Table (side).
The Table Jump graphic is highlighted.
4. Push Event Jump bottom button.