Filter
Top Products
Appendix B: Performance Verification (AWG710)
B-70 AWG710&AWG710B Arbitrary Waveform Generator User Manual
Check Gated Mode
1. Set the oscilloscope controls as follows:
2. Set the function generator (AFG310) controls as follows:
3. Follow the substeps below to set the AWG710 Arbitrary Waveform Generator
controls and to select the waveform file:
a. Push UTILITY (front–panel)!System (bottom)!Factory Reset
(side)!OK (side).
b. Push SETUP (front–panel)!Run Mode (bottom)!Gated (side).
c. Load the MODE.WFM file.
Refer to Loading Files on page B-62 for file loading procedures.
d. Push HORIZONTAL MENU (front–panel)! Clock (side).
Equipment
required
Two 50 Ω BNC coaxial cables, a 50 Ω SMA coaxial cable, a
SMA(Fe)–BNC(Ma) adapter, a BNC–T (male to 2 females) adapter, a
function generator, and an oscilloscope (TDS700).
Prerequisites
The AWG710 Arbitrary Waveform Generator must meet the prerequisites
listed on page B-61.
Vertical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CH1 and CH2
CH1 and CH2 coupling . . . . . . . . . . . . . . . . . DC
CH1 scale . . . . . . . . . . . . . . . . . . . . . . . . . . . 500 mV/div
CH2 scale . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 V/div
CH1 input impedance . . . . . . . . . . . . . . . . . . 50 Ω
CH2 input impedance . . . . . . . . . . . . . . . . . . 1 MΩ
Horizontal
Sweep. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 µs/div
Trigger
Source. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CH1
Coupling . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC
Slope. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Positive
Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mV
Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . NORMAL
Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Square
Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous
Parameters
Frequency. . . . . . . . . . . . . . . . . . . . . . . . . . . 10.1 kHz
Amplitude . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.0 V into 50 Ω (4.0 V into 1 MΩ)
Offset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0 V into 50 Ω (2.0 V into 1 MΩ)
Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Off