Filter
Top Products
Getting Started
AWG710&AWG710B Arbitrary Waveform Generator User Manual 1-11
Check Fuse
Check the fuse that it is the proper type and rating.
Remove the fuse from the fuse holder on the rear panel and check the fuse. To
remove the fuse, turn it counterclockwise with a screwdriver while pushing it in.
There are two types of fuses provided. Table 1-6 lists the fuse types and ratings.
Check Voltage Settings
Check that you have the proper electrical connections. The AWG710&AWG710B
Arbitrary Waveform Generator operates within the following power supply
voltage and frequency ranges:
Connect Power Cord
Connect the proper power cord from the rear panel power connector to the power
system.
WARNING. To avoid electrical shock, make sure that the power cord is
disconnected from the socket before checking the line fuse.
Table 1-6: Fuse and fuse cap part numbers
Fuse Fuse part number Fuse cap part number
0.25 inch × 1.25 inch (UL 198G, 3AG) : 10A
FAST, 250 V
159–0407–XX 200–2264–XX
5 mm × 20 mm (IEC 127) : 5A (T), 250 V 159–0210–XX 200–2265–XX
NOTE. The second fuse listed in the table above is approved under the IEC
standards. This fuse is used in equipment sold in the European market.
Line voltage range 100 - 240 V AC
Line frequency 48 - 63 Hz (100 - 240 V AC)
Maximum power 240 VA (220 VA:AWG710)