Filter
Top Products
Quick Editing
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-103
4. Specify the modification area using the cursors.
5. Press the Quick EDIT button on the front–panel to execute Quick Edit.
Exiting Quick Edit
When exiting Quick Edit, you can select whether or not to save the waveform
changes.
1. Press the QUICK EDIT button on the front panel.
2. Before Quick edit is exited, you are asked if you want to fix the current
changes.
3. Select the Yes, No, or Cancel side menu.
Setting Parameters
Interpolating Method
When changes are made to the waveform by turning a knob, the values of the
shifted points are calculated by interpolation. You can select either Linear or
Quadratic for the interpolating method.
Press the Interpolation side button to toggle between Linear or Quadratic.
Range of Smoothing
When changes are made to the waveform by turning a knob, the shifted points and
the points in the nonshifted area are linked smoothly. This is called smoothing.
This parameter specifies the extent (of the nonshifted points) to which smoothing
applies. The value may be 0 to 1000.
1. Press the Smoothing side button.
2. Use the general purpose knob or numeric keys for value.
Position of Center of
Vertical Extent
This specifies the center used for vertical scaling. The value may be -1.0 to 1.0.
1. Press the Vertical Origin side button.
2. Use the general purpose knob or numeric keys to change the value.
NOTE. When a waveform is loaded in the waveform memory, the changes made in
the Quick editor cannot reflect to the output. To reflect the changes to the output,
be sure to load the target waveform in the SETUP menu, enter into the editor, and
then enter into the Quick Editor.