Filter
Top Products
AWG710&AWG710B Arbitrary Waveform Generator User Manual 3-99
Quick Editing
Quick edit allows you to modify and output the currently edited waveform (with
the waveform editor) in real time by using the knobs on the front–panel. The Quick
Edit enables you to scale or shift the cursor–to–cursor data on the Waveform editor
screen along the vertical and/or horizontal axis. Use the vertical scale, vertical
offset, horizontal scale, and horizontal offset front–panel knobs.
If Update Mode is set to Auto with the waveform editor, waveform modifications
using the knobs are automatically updated to the waveform file and to the output
waveform.
Screen Display
Open a target waveform with the waveform editor, and then push the QUICK
EDIT button on the front–panel. The screen is the same as that of the waveform
editor in graphic mode except for the bottom and side buttons. A bottom button is
not available, and only three side buttons can be used for adjusting the editing
parameters. See Figure 3-24 for an example of the quick edit screen.
NOTE. You can enter into the quick edit mode only from the waveform editor.
You cannot enter into the quick edit mode when the AWG710B is set to the
Synchronous Operation mode.