Filter
Top Products
Chapter 13 Keyframe Effects
118
Specifying the Region and Edit Points
Specifying the Region and Edit Points
Selecting the region in which editing applies
Select the region in which the editing is applied by the effect consisting of
keyframes, using the region selection buttons in the numeric keypad control
block. (See step 2 (page 116) in “Recalling a register.”
Setting the edit points
Keyframe control block
To set the edit points, use any of the following operations in the keyframe
control block.
• To move the edit point to the keyframe immediately after the current time
(the position at which the effect is currently stopped), press the [NEXT KF]
button.
• To move the edit point to the keyframe immediately before the current time,
press the [PREV KF] button.
• To move the edit point to a keyframe specified by number, press the [GO TO
KF] button, then enter the keyframe number with the numeric keypad in the
numeric keypad control block, and press the [ENTER] button to confirm.
STOP
NEXT
KF
NORM REV
NORM
/REV
EFF
LOOP
EDIT
ENBL
KF
DUR
DELAY
EFF
DUR
COPY PASTE
DEL
SHIFT INS
PREV
KF
NEXT
KF
MOD UNDO
CONST
DUR
AUTO
INS
TURN
OVER
KF
LOOP
GO TO
TC
PAUSE
GO TO
KF
ALL
FROM
TO
FF
RE
WIND
RUN
EDIT ENBL button
Buttons used for editing
CONST DUR button