Filter
Top Products
Chapter 12 External Devices
88
Control of P-BUS Devices
a) 1: Off (no specification)
2: Store
3: Recall
4: Trigger
4
If in step 3 you selected 2 (Store), 3 (Recall), or 4 (Trigger), turn knob 3 to
select the register number or trigger number.
The indication for knob 3 changes to reflect the selection of Store, Recall,
or Trigger.
The setting is reflected in the list on the right of the status area.
5
Press [Set].
For the device selected in the list on the left of the status area, this sets the
action specified in step 4.
Repeat steps 2 to 5 as required for other devices.
Testing an action command
To produce a test output of the action command, press [Test Fire].
The action command is output from the 9-pin serial port of the DCU according
to the setting in the list on the left of the status area.
Clearing an action setting
To clear the setting for separate devices
Use the following procedure.
1
In the list on the left of the status area, select the device for which you want
to clear the action setting.
2
In the list on the right, select “Off.”
3
Press [Set].
To clear the action settings for all devices in a single operation
Press [All Off].
Knob Parameter Adjustment Setting values
3 Store No Register number for Store 1 to 99
3 Recall No Register number for Recall 1 to 99
3 Trigger No Trigger number 0 to 15