Filter
Top Products
171Snapshot Operations in the Menus
Chapter 14 Snapshots
5
In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
1
Press [XPT Hold], turning it on.
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
2
Using either of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
• To select all registers, press [All].
3
Press [On].
This enables cross-point hold on the selected bus or buses.
To switch cross-point hold off, press [Off].
To apply the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Turn the knob to set the effect dissolve duration.
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
Knob Parameter Adjustment Setting values
2 Bus Bus name selection –
3 Num Select number of buses –
Knob Parameter Adjustment Setting values
2 Duration Dissolve duration 0 to 999 (frames)