Filter
Top Products
Chapter 11 DME Operations
70
DME Special Effect Operations
2
Set the following parameters.
a) The way in which the trail disappears is affected by both Decay and Trail Dust parameter
adjustments.
Motion Decay Settings
When the video image is a moving image, you can blur the motion by creating
motion trails (or afterimages).
For sample images, see “DME Special Effects” in Chapter 1 (Volume 1).
Note
When you turn on motion decay, if the trail or keyframe strobe effect is on, it
automatically goes off.
Blurring image motion
Use the following procedure.
1
In the DME menu, select VF5 ‘Light/Trail’ and HF3 ‘Motion Decay.’
The Motion Decay menu appears.
2
Press [Motion Decay], turning it on.
This enables motion decay, and you can now use the knobs to adjust the
parameters.
3
Set the following parameter.
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
Knob Parameter Adjustment Setting values
1 Trail Dust Amount of the trail disappearing as
stardust
a)
0.00 to 100.00
2 Dust Soft Timing with which stardust
disappears
0.00 to 100.00
3 Dust Size Size of stardust 0.00 to 100.00
4 Dust Aspect Aspect ratio of stardust –100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Video Decay Degree of blurring of the video
signal
0.00 to 100.00
a)