Filter
Top Products
Chapter 16 Engineering Setup
232
Setup Relating to Operations From the Control Panel
Protect: In this mode, pressing a panel button cannot change the
cross-point settings.
Note
The button ON/OFF state is preserved in each of the “Normal” and
“Protect” modes. For example, if the [XPT HOLD] buttons are “ON” in
the Normal mode, and you switch to Protect mode, then if the [XPT
HOLD] buttons were “OFF” in this mode the previous time, the [XPT
HOLD] buttons go off, and if they were “ON” they light.
Setting trackball, joystick, and double-click sensitivity
Use the following procedure.
1
In the Panel>Operation menu, press the [Sensitivity].
The Sensitivity menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Trackball and Z-ring sensitivity in normal mode: In the <Trackball
Normal Mode> group, select [×1], [×2], or [×4].
Trackball and Z-ring sensitivity in fine mode: In the <Trackball Fine
Mode> group, select [
1
/
2
], [
1
/
4
], or [
1
/
8
].
Joystick sensitivity in normal mode: In the <Joystick Normal Mode>
group, select [×1], [×2], or [×4].
Joystick sensitivity in fine mode: In the <Joystick Fine Mode> group,
select [
1
/
2
], [
1
/
4
], or [
1
/
8
].
Touch sensitivity for recalling menus by double-clicking buttons: In
the <Double Click> group, select [Fast], [Normal], or [Slow].
Main split fader specification
In the <Main Split Fader> group of the Panel>Operation menu, select
[Left] or [Right].
Screen Saver and Other Settings (Maintenance Menu)
To make settings relating to the screen saver, etc., use the Panel>Maintenance
menu.
To display the Maintenance menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF7 ‘Maintenance.’