Filter
Top Products
Chapter 11 DME Operations
30
DME Special Effect Operations
4
Set the parameters.
• When Video/Key is selected
• When Video is selected
5
To cancel black level leaking that can occur at the edge of the screen when
the Defocus effect is enabled, press [Clean Defocus], turning it on.
Blur Settings
This effect blurs the entire image.
Applying the Blur effect
Use the following procedure.
1
In the DME menu, select VF2 ‘Video Modify’ and HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2
Press [Blur], turning it on.
The Blur effect is enabled. You can adjust the blurring of video and key
signals with the knobs.
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
signal
0.00 to 100.00
2 V Vertical defocusing of video
signal
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video signal
H value shown