Filter
Top Products
Chapter 13 Keyframe Effects
134
Time Settings
Setting the keyframe duration
You can set the value of the keyframe duration independently for each
keyframe, by the following method.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect on the keyframe for which you want to set the duration.
The time from this keyframe to the following keyframe is what you set.
3
Press the [KF DUR] button, turning it on.
The display in the numeric keypad control block shows “KF DUR”
followed by the duration of the current keyframe (seconds:frames).
4
Using the numeric keypad in the numeric keypad control block, enter the
timecode value for the keyframe duration, as a maximum of four digits.
For example, to set 9 seconds and 20 frames, enter 920. You can also use
the [TRIM] button to enter a difference value. (See “To enter a difference
value” (page 119).)
5
Press the [ENTER] button to confirm the entry.
This changes the keyframe duration to the new setting.
Note
In addition to the above operation, the keyframe duration may also be
automatically changed as a result of changing the effect duration. (See the
next section.)
Setting the Effect Duration
To set the effect duration, use the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Press the [EFF DUR] button, turning it on.
The display in the numeric keypad control block shows “DUR” followed
by the effect duration (minutes:seconds:frames).